AmeriGlide Stair Lift Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AmeriGlide Stair Lift. AmeriGlide Stair Lift 15 pages. Stair lift

Imprimer la page
I N S TA L L I N G P L A S T I C C H A I N A N D T R AV E L I N G P O W E R C A B L E
4 After laying the trailing cable and
guide chain into the track channel,
pull down on the cable to make
sure there is no slack and it is
straight under the left channel
tight against the side
I N S T A L L I N G
call-send plugs
AC
plug
AC Powered Header
1
For AC Powered Lifts
Locate the power cable and plug into
the side of the upper track cover. The
green light
should light up - indicating
the unit is receiving power. If not,
check the circuit breaker under the
green light.
CAUTION: Do not ride. Track brackets are
not yet completely anchored.
5 While holding the cable tight in
place, use a ¼" driver to run the
self drilling screw into the track
utilizing one of the two holes in
the guide chain mounting bracket.
Two holes are provided in the mounting
bracket in the event that one of the
holes would happen to be directly over
a splice between two pieces of track.
T H E
P O W E R
DC
plug
green light
not supplied on
DC powered lifts
DC Powered Header
2 For DC Powered Lifts
The batteries need to be connected
prior to the unit being installed.
To do this, connect the negative
wire (black wire) to the battery
next to the motor on top of the unit.
The charger must be plugged into
115 VAC grounded outlet, and left
plugged in all the time for the batteries
to properly charge. TheOwners Manual
has a page that describes the
lights that show on the charger.
C O R D
call-send plugs
11