Amerihome SSUSK1816 Instructions de montage - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Amerihome SSUSK1816. Amerihome SSUSK1816 2 pages. Stainless steel utility sink
Imprimer la page
ITEM # SSUSK1816
A
1 piece sink body
E
1 piece drainer
1
B
B
D
C
A
Place the sink (A) upside down on the floor.
Use the hex wrench (D) to remove 8 pcs hex screws (C) from
four corner support of sink (A).
Insert each leg (B) into each corner support of sink (A).
Use the hex wrench (D) to tighten the hex set screws (C) into
the corner support. Each corner support requires two hex screws.
3
H
G
According to the height of the baffle plate of the sink (A), drill holes in
the wall.
Then put each plastic tubbing (H) into each hole.
Insert each screw (G) through the hanging bar (F) into the
plastic tubbing (H).
STAINLESS STEEL UTILITY SINK
B
4 pieces leg w/feet
F
1 piece hanging bar
B
B
C
D
F
C
8 pieces hex screws
G
2 pieces screws
for hanging bar
2
E
E
Separate the whole drainer (E).
Then reassemble the drainer on the sink as shown above.
4
Put sink (A) on the hanging bar (F).
Rotate the leg feet pads to compensate for differences in
floor surface.
D
1 piece hex wrench
H
2 pieces plastic tubbing
for hanging bar