Ameriphone Dialogue RC-200 Manuel d'utilisation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ameriphone Dialogue RC-200. Ameriphone Dialogue RC-200 19 pages. Remote control speakerphone
Imprimer la page
CHAPTER 4
INSTALLATION
A. Battery (included with RC–200)
Speakerphone
1. Six "AA" size,
Nickel Cadmium
(NiCad) recharge-
able batteries are
used for back–up
during a power out-
age (Fig 3). They
power the DIA-
LOGUE RC for
approximately
3 hours. DO NOT USE ALKALINE
BATTERIES, they will damage your
equipment.
Remote Transmitter
2. Install the "23A" size 12V alkaline cigarette
lighter battery in the Remote Transmitter
(included) as shown (Fig 4). With normal
usage, it lasts 6–12 months. If the power
indicator light is faint or does not come on
when the button is pressed, replace the
battery. The Remote Transmitter has an
operating range of up to 40 feet.
Power
indicator
Jack for
accessory
switch
Battery
compartment
Figure 4 – Remote Transmitter
4
Figure 3 – battery
compartment
Thread both
ends of necklace
through hole and
tie a small knot.
(optional)
B. Connections
Figure 5 – Connection of phone line and
AC adapter
1. Connect the phone line and AC adapter
as shown.
2. Set the tone/pulse selector (T/P) to T if
you have touch tone service, set to P if
you have pulse dialing (rotary). (See Fig 2)
The DIALOGUE RC can be placed on a desk,
or mounted on the wall. Do not put the
DIALOGUE RC on or next to metal surfaces,
computers, televisions, radios, microwaves, or
other electrical equipment that can cause inter-
ference to the wireless signal from the Remote
Transmitter.
C. Setting up your RC
The DIALOGUE RC comes with the following
operating settings from the factory:
1. Scan rate is 5 seconds per memory
location.
2. Voice activated answering (RC–200
only) is off.
3. Unanswered call indicator is on.
4. Voice mail indicator (RC–200 only) is
off.
5. Tone/pulse switch set to Tone.
6. Ring volume set to Hi.
7. "0" (operator) is programmed into first
memory location of M1.
8. Remote flash switch (RC–200 only) is off.