Door Controls DC One Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Door Controls DC One. Door Controls DC One 20 pages. Automatic sliding door retrofit drive assembly

Imprimer la page

NOTE: Approximate installation time: 2 to 4 hours – 1 Technician.

COMPONENTS

Motor / Gearbox (1)



Control (1)



Drive Belt (1) – Optional on some systems



Belt Brackets (2)



Idler / Tensioner (1) – When required



Decal Set (1)



AAADM Owner's Manual (1)



AAADM Daily Safety Check Decal (1)



OPTIONAL:

Bottom Guides (1 or 2)



Top Rollers (2 or 4)



HEADER PREPARATION

WARNING – Shut off and disconnect all primary electrical power to the door header before proceeding any further.



Disconnect all sensor wiring from the control and/or interface board. Keep the wiring available if you intend to re-use the sensors



Disconnect all safety beam wiring from the control and/or interface board. Keep the wiring available if you intend to re-use the



safety beams.

Disconnect all switches from the control and/or interface. Keep the switches in place if you intend to re-use them for the retrofit.



Remove the entire existing drive system from the header (motor/gearbox, control, interface, belt, chain, cables, etc.). Do not



throw away any mounting hardware as it may be used to mount the DC One components (see drawings).

BOX CORES and USED COMPONENTS (motor/gearbox, control, etc.) use the return shipping label and ship to Door Controls.



DOOR PREPARATION

Remove and replace the bottom guides (If needed).



Remove and replace top rollers (If needed).



IMPORTANT NOTE:



•

MOTOR AND CONTROLLER INSTALLATION

Install DC One motor/gearbox and controller per the instructions shown on the enclosed drawing.



DC One V3 Installation Manual

M-0015 REV 06222017 P10

Manual resistance of the sliding panels, with no belt attached, should not exceed 8 lb for bi-parts, or 4 lb for

single slides. Use a force gauge to push against the door to slide it open and closed to check the resistance.

Be sure to check for mechanical door stops at each end of the header. If door stops are missing, they may be

ordered as an accessory from Door Controls.

Do not install new belt brackets yet, this will allow more working room when installing the control and related

wiring.

Page 2 of 15