DAB MCE-110/C Instructions pour l'installation et l'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Instructions pour l'installation et l'entretien pour {nom_de_la_catégorie} DAB MCE-110/C. DAB MCE-110/C 18 pages.
Imprimer la page
N.B. Temperature reading via sensor T is only enabled in the following control modes: T constant increasing
and ∆T constant
.
N.B. Temperature reading via sensor T1 is only enabled in the following control modes: T1 constant increasing
and ∆T constant
For operating modes T constant and ∆T constant see paragraphs 7.1.5 and 7.1.6
N.B: The input of temperature sensor T type NTC is mutually exclusive with the 0-10V analogue input connected to the same poles of
the 18-pole terminal block.
5.5.4
Outputs
The connections of the outputs listed below refer to the two 3-pole terminal boards J3 and J4 indicated with the screen-printing OUT1
and OUT2 below which is also indicated the type of contact for the terminal (NC = Normally Closed, C = Common, NO = Normally
Open).
Type of contact
Max. bearable voltage [V]
Max. bearable current [A]
Max. accepted cable section [mm²]
Table 4: Characteristics of the output contacts
OUT1
Presence/Absence of alarms in the system
OUT2
Pump running/Pump stopped
In the example shown in Figure 9 the light L1 is lit when there is an alarm in the system and it goes off when no kind of malfunction is
found, whereas the light L2 is lit when the pump is running and goes off when the pump is stopped (NC logic).
Figure 8: Connection of NTC sensor for temperature measurement T
.
Characteristics of the output contacts
NO, NC, COM
250
5
2,5
3,80
Functions associated with the outputs
ENGLISH
If resistive load
If inductive load
40
/decreasing
/decreasing