Ameristep Pro Series Manuel d'instruction et de sécurité - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et de sécurité pour {nom_de_la_catégorie} Ameristep Pro Series. Ameristep Pro Series 4 pages.

Imprimer la page

SET-UP

After removing Blind from case, unbuckle cinch strap

Figure 1. Unfold each corner outward and lay flat on

ground as shown in Figure 2. Be sure material is NOT

twisted or overlapping ends of poles.

Figure 1

Figure 2

Note: If you cannot access

the wall hub when starting

to lift the blind in Step 4,

rotate the opened wall left

to right slightly as shown

in Figure 4, while lifting.

This will allow the blind to

open so you can pull the

remaining hubs into place.

Figure 4

NOTE: Illustrations used are for demonstration purposes only and may not depict actual product.

Firmly pull one of the hubs until it pops open.

Note:

You can start with any hub but it is usually best

to open the roof hub first.

Figure 3

Lift the blind until you can access another wall hub and

firmly pull until wall pops out as shown in Figure 5.

Figure 5

Continue around blind, pulling each center hub until

all but door side hub is extended as shown in Figure 6.

Figure 6

Your blind should now be set up. Use stakes to

secure blind to the ground. Adjust windows,

and add native brush to stubble pockets

(if available on your model) to optimize

your camouflage.

IMPORTANT: Make sure door zippers are fully closed

so wall will keep tension. Now pull DOOR HUB out.

Figure 7

Be sure to follow these guidelines

for using your Product. READ AND

UNDERSTAND ALL INSTRUCTIONS

and WARNINGS FIRST.

If you have any questions regarding

the use of this product contact our

Customer Service Department.

GSM, LLC • P.O. Box 535189 • Grand Prairie, Texas 75050

877-269-8490 • WWW.AMERISTEP.COM