DoorHan SLIDING-2100 Manuel d'installation et d'utilisation - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} DoorHan SLIDING-2100. DoorHan SLIDING-2100 16 pages. Drive
Également pour DoorHan SLIDING-2100 : Manuel d'installation et d'utilisation (12 pages), Manuel d'installation et d'utilisation (12 pages)
Imprimer la page
Adjustment of mechanical regulators
6.
PRoGRAMMInG oF ReMote ContRoLs
1. M emory cleaning. After power supply is on, hold down the "CODE" button for 10 seconds. The "A" indicator will blink for
10 seconds, then it will go out for 2 seconds and blink twice again to confirm that the codes were erased.
2. C ontrol's code storing. To store the code of the remote control, press and hold down for 3 seconds the "CODE" button. The
red A indicator will blink. Release the button. press the selected button on the remote control (which you wish to control
the unit with) within 10 seconds during blinking of the red indicator. Hold down the button on the remote control until the
red "A" indicator lights up for 2 seconds and goes out. The code of the remote control is stored.
3. To add several remote controls, repeat the procedure of code storing for them. You can add 65 remote controls.
4. I f no control commands are given, the automatic exit from the waiting mode will be in 10 seconds In case of disconnection
of the control unit from the mains, the programmed data will be stored.
7.
ReLeAse oPeRAtIon
To release the operator, use the lever of the built-in release. After releasing
you can open and close the door by hand.
If you need to open the door by hand in case of power failure or operator
trouble, use the release.
1. Insert the key into the lock (pic. 1).
2. Turn the key clockwise.
3. Without removing the key, open the release lever (pic. 2).
4. Turn the key counterclockwise and remove the key from the lock.
5. Move the door by hand.
Return to normal operation of the system
To avoid the unprompted push when activating the door, turn off the power
supply of the system before blocking the operator.
1. Insert the key into the lock.
2. Turn the key counterclockwise.
3. Without taking out the key, close the release lever tightly.
4. Turn the key clockwise and remove the key from the lock.
5. Move the door by hand until the operator is blocked.
prOgraMMIng Of reMOte cOntrOls
Turn the corresponding regulator clockwise to encrease the setting.
Turn the corresponding regulator counterclockwise to decrease the setting.
Automatic close is adjusted using the Auto Cl regulator. For that you
should set it in any position except the end left one. Turning the regulator
right increases pause time before automatic close.
Pic. 1
Pic. 2
1
1
2
2
11