DoorHan RCBLACK-4 Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DoorHan RCBLACK-4. DoorHan RCBLACK-4 2 pages.

Imprimer la page

EC DECLARAtIon of ConfoRmItY

We: DoorHan Europe s.r.o.

Bozeny Nemcove 1689, 43201 Kadan, Ceska Respublika Herewith declare

under sole responsibility that:

Additional note:

These products have undergone tests in a typical uniform configuration

(all products manufactured by DoorHan Europe s.r.o.)

01/03/2010

1. DESCRIptIon

Remote control transmitters DoorHan are meant for DoorHan automat-

ics or any other device with the DoorHan radio receiver control. You can

control one or more (up to 4) different devices (gates, barriers etc.) with

the help of one transmitter.

2. tECHnICAL SpECIfICAtIonS

model

Battery

Working frequency

Quantity of channels

Working temperature range

3. pRogRAmmIng

programming of the remote controls with reciever DHRE-2

1) Before programming the former codes can be erased from the

memory of the recipient (it is recommended by the first setting). In order

to do that, hold down the key 10 sec (SW1 for connector CH1, SW2 for

connector CH2). The indicator LED1 will blink for 10 sec, then it will go out

for 2 sec and blink twice to confirm erasing of the codes.

2) To record the new code hold down for 3 sec the key «SW1» on the

recipient card, to make settings of the electric operator connected to the

output CH1 and the key «SW2» - to make settings of the electric operator

connected to the output CH2, at that the indicator LED1 will light. After

that press the necessary key on the remote control unit for 2-3 sec. At-

tention! after the operation is completed only one key can be stored in the

memory of the recipient.

3) To make settings for other remote controller repeat record proce-

dures with other remote controllers.

programming of the remote control units with build-in electric

operator SE-750(1200) reciever.

1) Before programming the former codes can be erased from the mem-

ory (it is recommended by the first setting). In order to do that, press and

hold down the key «R». The «0» will appear on the display. Hold down the

key «R» until the «0» disappears.

2) For each of the buttons there is a certain control channel (pic.),

which selection operation is described in Item 5 («Control key setting»).

The operator's default control button is key 1 or key 2 depending on the

controller's program.

3) To record the code of the remote controller press the key «R». On

the left part of the display the "0" will appear and disappear immediately.

Press the key on the remote controller twice.

4) Other remote control units are programmed in a similar way.

For removal of transmitter from memory of the receiver: Press and

keep during 8 with pressed button R, the indicator (zero in the bottom of

the display will not go out yet, the short sound signal will thus be distrib-

uted. For other information use the manual of door operator.

• Declares that:

The device model RCBLACK-4

• complies with the essential safety requirements of the

following directives:

73/23/EEC and subsequent amendment 93/68/EEC

89/336/EEC and subsequent amendment 92/31/EEC and

93/68/EEC

Mikhail Kiselev

InStALLAtIon mAnUAL

RCBLACK-4

-20 °С ... +50 °С

Managing Director

Date signature

RCBLACK-4

12V, type 27A

433,25 MHz