4. REPAIR
4-1. Notes on Service Part Replacement (and Disassembling / Reassembling) in Asia
Service part
Logic board ass'y
(QM3-1691)
Operation panel
unit
(QM3-1358)
4-2. SERVICE MODE
Number of times the
Stop/Reset button is pressed
12 times
13 times
14 or more times
<How to set the ink absorber counter value>
1)
In the ink absorber counter setting mode, press the Stop/Reset button the specified number of
time(s) according to the ink absorber whose counter value should be transferred to the EEPROM.
Times
0 times
1 time
2 times
3 times or more
2)
Press the ON/OFF button to proceed to the next step.
3)
The ink absorber counter value can be set in 10% increments by pressing the Stop/Reset button.
Press the Stop/Reset button the appropriate number of time(s) to select the value which is
closest to the actual ink amount in the ink absorber.
Times
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
Notes on replacement
- Before removal of the logic
board ass'y, remove the power
cord, and allow for approx. 1
minute (for discharge of
capacitor's accumulated
charges), to prevent damages
to the logic board ass'y.
- Before replacement, check the
ink absorber counter value. If
the value is 7% or more, also
replace the ink absorber when
replacing the logic board ass'y.
If the ink absorber is not
replaced, then set the ink
absorber counter value to the
replaced new logic board
ass'y.
LED
Green
Button and LCD test
Orange
Sets the ink absorber counter
value (ink amount in the ink
absorber)
Returns to the menu selection
LED
Green
Main ink absorber
Orange
Platen ink absorber
Green
Both the main and platen ink absorbers
Returns to the ink absorber counter setting mode
Ink absorber counter value to be set(%)
0%
10%
20%
30%
40%
50%
60%
70%
Adjustment/settings
After replacement:
1. Initialize the EEPROM.
2. Reset the ink absorber
counter.
If the ink absorber is
not replaced, set the
ink absorber counter
value to the replaced
new logic board ass'y,
while referring to 4.2,
"Service Mode" below.
3. Set the destination in
the EEPROM.
4. Perform the print head
alignment in the user
mode.
After replacement:
1. Check the buttons and
the LCD.
See 4.2, "Service
Mode."
Function
(6/6)
Operation check
- EEPROM print
- Service test print
- Printing via USB
connection
- Camera Direct print
Remarks
See below for how to set
the ink counter value.
Imprimer la page