Astralpool SLX Instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Astralpool SLX. Astralpool SLX 4 pages. Underwater niche lights for fibreglass pools
Également pour Astralpool SLX : Manuel d'installation et d'utilisation (6 pages), Instructions détaillées (6 pages), Manuel de démarrage rapide (4 pages), Manuel d'instructions d'installation (7 pages)

10. Clean up any excess silicone from the front and rear of the niche.

11. Allow the silicone to cure for approximately 12 to 15 hours before fitting the electrical conduit.

12. Glue a length of 25mm electrical conduit to the niche conduit socket using PVC solvent cement.

Ensure the conduit extends above the water level of the pool. If a draw wire is not being used, the

cable (item 20348 or 20344) must be fitted simultaneously with the conduit installation. Starting at the

niche, run the cable though the conduit to the power supply. Leave 1m of cable surplus inside the

niche, complete with the end of the cable with the plug, and coil up inside the niche until ready to fit

the light. Ensure the cable gland inside the niche is fully tightened around the cable.

13. Install a second conduit to return below ground level and away to the power supply. Both conduits

should be glued into a draw box to allow for future service.

To stop water siphoning

from the pool, the conduit

needs to have an air gap.

Pool / Spa wall

Collar Nut

Inst.376 Astral Pool Light Niche For Fibreglass Pool Instructions V10.15

Collar Nut

Silicone bead

Remove the excess silicone

O-ring

Pool wall

Silicone bead

Remove the excess

silicone

Conduit to DC Low

Voltage power supply

Niche

Draw box above waterline