Canon PIXMA MP620 series Manuel d'entretien - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Canon PIXMA MP620 series. Canon PIXMA MP620 series 46 pages. Installing your multifunction on additional computers windows os
Également pour Canon PIXMA MP620 series : Mise en place (4 pages), Manuel complémentaire (6 pages), Instructions d'installation (4 pages), Manuel (20 pages), Spécifications (2 pages), Manuel (10 pages), Manuel (8 pages), Manuel de configuration du réseau (22 pages), Manuel d'installation (11 pages), Manuel de connexion (19 pages), Manuel d'installation (7 pages), Installation (21 pages)

Imprimer la page
Canon PIXMA MP620 series Manuel d'entretien
2-2. Service Call Errors (by Cyclic Blinking of Alarm and Power LEDs)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink, and the corresponding error code with the
message,
"Printer error has occurred. Turn off power then back on again. If problem persists, see the manual." is displayed on the LCD.
Cycles of
blinking of
Error
Alarm and
Power LEDs
2 times
Carriage error
3 times
Line feed error
4 times
Purge cam sensor
error
5 times
ASF (cam) sensor
error
6 times
Internal temperature
error
7 times
Ink absorber full
Error
Conditions
code
[5100] An error occurred in the carriage
encoder signal.
[6000] An error occurred in the LF encoder
signal.
[5C00] An error occurred in the purge unit. (1) Foreign material or paper debris around the
[5700] An error occurred in the ASF cam
sensor.
[5400] The internal temperature is not
normal.
[5B00,
The ink absorber is supposed to be
5B01]
full.
Message on the LCD:
Ink absorber full. Service
required.
Error codes:
7 / 44
Solution
(Check points and replacement items)
(1) Smearing or scratches on the carriage slit
film;
clean the timing slit film.
(2) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
(3) Ink tank conditions;
re-set the ink tanks.
(4) Cable connection
(5) Part replacement:
- Timing slit disk film
- Carriage unit
- Logic board
- Carriage motor
(1) Smearing or scratches on the LF / EJ slit
film;
clean the LF / EJ slit film.
(2) Foreign material or paper debris in the LF
drive;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- LF / EJ slit film
- LF / EJ timing sensor unit
- Paper feed roller unit
- Logic board
- Paper feed motor
purge drive system unit;
remove foreign material.
(2) Cable connection
(3) Part replacement:
- Purge drive system unit
- Logic board
(1) Cable connection
(2) Part replacement:
- ASF unit
- PE sensor board unit
- Logic board
(1) Cable connection
(2) Part replacement:
- Carriage unit
- Logic board
- Print head
(1) Ink absorber condition
(2) Part replacement:
- Ink absorber kit
(3) Ink absorber counter value in the EEPROM;
reset the ink absorber counter.