DoorKing MicroCLIK 8057-083 Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DoorKing MicroCLIK 8057-083. DoorKing MicroCLIK 8057-083 3 pages. Rf receiver

Imprimer la page

Programming

M a

s t e

r C

o d

e B

u t t

o n

Facility Codes:

Unique code for transmitter and located on back of transmitter (Fc).

1. Press

and the four-digit Master Code.

2. Press

"BEEP"

3. Enter the two-digit facility code (01-10), then press

4. Repeat steps 2 and 3 to enter additional facility codes.

5. Press

TOGETHER to end programming.

Transmitter Button Number:

1. Press

and the four-digit Master Code.

3. Enter the button number that the receiver is to respond to (1-2-3), then press

5. Press

TOGETHER to end programming.

Relay Strike Time:

The amount of time the receiver relay activates.

1. Press

and the four-digit Master Code.

2. Enter a two-digit number (00-99) for the relay activation in seconds, then press

3. Press

TOGETHER to end programming.

Program the Master Code:

receiver memory for all programming. You MUST program a MASTER CODE first.

1. Press Master Code Button

Note: Receivers manufactured before Rev E (2/01) require

the receiver case to be opened to access the master code

button. All other programming steps remain the same for

the receivers.

2. Choose and enter four-digits on the keypad

Important Note:

code . There is NO way of retrieving the master code after it has been programmed in. If you

forget it, you will have to program in a new master code but all other previously programmed

information will remain intact.

Note: Be sure to increment this number each time another facility code

for the FIRST facility code.

is entered - up to 10, use 0 for facility code 10 if required.

"BEEEEEEEEEP"

Used to identify the individual transmitter button that will activate the receiver (Up to 3 buttons).

"BEEEEEEEEEP"

The master code is the four-digit number required to gain access to the

Keep this instruction sheet for future reference after writing down the master

"BEEP"

Write Down Your Master Code

1st Digit 2nd Digit

any four numbers

Note: 00 programs the relay for 1/2 second.

"BEEP"

01 programs the relay for 1 second etc.

Inglewood, California 90301

3rd Digit 4th Digit

then press

"BEEP"

120 S. Glasgow Avenue

U.S.A.