Canon PIXMA MX700 Series Manuel de configuration du réseau

Parcourez en ligne ou téléchargez le pdf Manuel de configuration du réseau pour {nom_de_la_catégorie} Canon PIXMA MX700 Series. Canon PIXMA MX700 Series 32 pages. Office all-in-one printer
Également pour Canon PIXMA MX700 Series : Manuel de nettoyage (7 pages), Manuel complémentaire (6 pages), Instructions d'installation (2 pages), Brochure & Specs (2 pages), Informations techniques (2 pages), Manuel d'entretien (44 pages)

Network Setup Guide

This manual contains the setup information required to use the machine over wired LAN.

If you use the machine with USB connection, refer to your setup sheet.

Introduction

To use the machine connected to a computer, you need to install the software called "MP Drivers" in

the computer.

The following two connection types are described in this manual.

Important

A hub and LAN cable are required to connect this machine to a LAN. These must be purchased

separately.

If the installation and adjustment of the machine have not been finished, refer to your setup sheet to set

up the machine properly.

Note

The configuration and the type of the device vary depending on your network environment. For details,

refer to your device's instruction manual or contact its manufacturer.

In an office setup, consult your network administrator.

Setting up for use over LAN

When the machine has not been connected to the

network, perform this setup to use the machine over LAN.

This setup procedure requires settings to be performed on

the machine and the computer.

Note

To set up the machine that is not yet connected to a LAN, connect the machine and the computer with a

USB cable.

Even if the machine has been set up to be used with the USB connection, follow the setup procedure

described in this manual to connect the machine to a LAN for the first time.

Q T 5 1 3 8 6 V 0 1