Astralpool RPB Manuel d'installation et d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Astralpool RPB. Astralpool RPB 16 pages. Robotic pool cleaner

Astralpool RPB Manuel d'installation et d'utilisation

Maintenance

CLEAN THE FILTER BAG AFTER EVERY CLEANING CYCLE
a. Unplug the power supply. (Please keep the plug away from contact with
water).
b. If the unit is in the pool, gently pull the cleaner toward you using the cable until
the handle is within reach. Use the handle (not the cable) to pull the cleaner
out of the pool after allowing most of the water to drain from the unit.
c. Lay the unit on its back on a smooth surface (in order to prevent scratches on
the machine body), release the lock tabs and remove the bottom lid
assembly.
1
Smooth Surface
3
5
6
30°C
2
Swivel Tab
4
Filter Bag
7
label
d. Remove the filter bag from the support bars, turn it inside out and wash off all the dirt with a
garden hose or in a sink. Squeeze the bag gently until the rinse water is clear. If necessary,
machine wash the bag using only cold water with NO DETERGENT!
e. Re-install the bag on the support bars with the label in the center of one of the long sides of the
bottom lid.
f. Re-install the bottom lid assembly in the body. Push down on it until lock tabs will snap into
place properly.

Storing the Robotic Cleaner

Follow these instructions to store the robotic cleaner when not in
use:
1. Disconnect the power cord from the wall outlet.
2. Disconnect the floating cable from the power and control unit.
3. Spread out the floating cable and release any twists in the
cable.
4. Wash the cleaner unit interior space with fresh water and let it
dry.
5. Roll the floating cable and place it ON THE CLEANER unit.
Caution: DO NOT ROLL the floating cable ON THE HANDLE
of the cleaner unit.
6. Store the robotic cleaner components in a dry, closed location.
7. Verify that the power and control unit is not exposed to water.

Checking Water Outlet Propeller

It is recommended to periodically clean debris
and hair from the propeller of the water outlet:
1. Remove the screws (3) that holds water outlet
cover(2).
2. Remove the water outlet cover (2).
3. Clean any hairs, dirt, or debris.
4. Verify that the propeller (1) is not broken.
5. Return the cover (2) and fasten it with the
screws (3).
9
3
2
1