Astrapool Viron Series Manuel d'installation et d'utilisation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Astrapool Viron Series. Astrapool Viron Series 14 pages. Salt chlorinator
1.0 INTRODUCTION
Congratulations on your purchase of the Viron series salt chlorinator. The correct pH balance of your pool water
significantly increases the effectiveness of the chlorine in the water and if not maintained at the correct level, can cause
harm to the interior finish of your swimming pool or spa and reduce the disinfection time of the chlorine.
The purpose of the Viron series chlorinators is to significantly reduce the level of daily and weekly maintenance required to
keep your pool and spa sparkling clean and healthy to swim in.
These installation and operating instructions will guide you through installation, operation and maintenance of your new
chlorinator. Regular maintenance will ensure many years of trouble free operation.
2.0 INSTALLATION
2.1 Mounting the Controller: Choose a location that is preferably out of direct sunlight, near the filter system. The
controller should be located 1 metre above ground level to prevent rain splash back or sprinkler system damage to the
underside of the controller. The controller must be mounted on a vertical surface/wall. If mounted on a post, a flat sheet
20mm larger than the controller housing must be used.
a. Mount the wall bracket using the screws provided on a secure wall.
b. Glue Chlorinator cell into line as per drawing below after filter, heater and solar (if installed).
c.
Plug filter pump 3 pin plug into underside of Controller.
d. Connect 4 wire cell cable ensuring matching colours.
e. The cell must be installed with the barrel unions underneath and the cell should be horizontal. Both 40mm and
50mm fittings have been provided. Make sure that the 'o'rings are correctly fitted and the unions are done up
tightly. Flow direction through the cell is critical – refer to label on housing.
f.
Hang Controller on wall bracket and plug power supply lead into 3 pin 10 amp outlet.
Inst305 - Viron Series Chlorinator Instructions V05-17
4