doping S9 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} doping S9. doping S9 6 pages.
Imprimer la page
EN
Lighting effects:
Front panel of the device may be lit with multicoloured LED diodes.
These light effects may be switched on by sliding the switch LIGHT-ON-OFF (8) in position
LIGHT.
Microphone effects
By temporarily pressing the microphone key
, you can play any of the 12 (6+6) microphone
effects.
By pressing the key
for 2 seconds, you can choose the next effect.
Voice changer
By pressing the microphone key VOICE CHANGER you can change your voice to modes "OLD
MAN" "MONSTER" "WOMAN" "REAL VOICE"
Echo effect
By pressing the front panel key [Mode] (2) for 2 seconds, you can switch on/change the degree
of echo effect.
Recording from microphone to USB flash drive
• The maximum length of the recorded material depends on the capacity of the memory device.
• Records will be saved in the JL_REC folder.
1. Turn off the sound system with the switch LIGHT-ON-OFF (8).
2. Insert the USB flash drive into the USB socket (11).
3. Turn the main volume control VOLUME (1) to the minimum.
4. Move the microphone switch to the ON position.
4.1 Insert the microphone jack into the MIC1 (15) socket (1) or/and MIC2 (14).
5. Turn on the sound system with the switch LIGHT-ON-OFF (8).
6. Press the [Rec] (4) key.
7. Speak into the microphone and set the desired sound level with the control VOLUME (1).
8. To finish recording, briefly press the [Rec] (4) key. The record will be saved on the flash drive.
• If the recording fails, make sure that the flash drive still has a free space.
Playback of the microphone recordings
After completion of the recording, the last recording will be played automatically. If you want to
play other microphone records, press the key [
] (7).
To exit the microphone recording mode, briefly press the [Rec] (4) key.
PROVISIONS FOR PROPER USE
This is a complex device and it must be treated carefully. For device to serve for a long time and
trustworthy, please take into consideration the following:
1. Do not place the device in a very hot place (over 40˚C). In heat, electronic devices and
batteries damage faster and plastic details can even become deformed.
2. make sure the device is not in contact with water and any other liquids.
3. Do not draw the device near powerful sources of electric field and static electricity.
4. Do not arbitrarily open the device and repair it.
- 5 -
3510007