Dor-O-Matic 1990 Series Manuel d'instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Dor-O-Matic 1990 Series. Dor-O-Matic 1990 Series 8 pages. Concealed vertical rod panic device
Imprimer la page
1
Install rod assemblies (continued).
1.6. Check latch operation and rod length adjustment:
1.6.1. Place traveler over rod ends.
1.6.2. Slide traveler up. Top latch should release and hold rods in up position, and bottom
latch should be completely retracted (flush with bottom edge of door).
1.6.3. Move top latch back to locked position. Rods should drop down, locking top latch
and extending bottom latch approximately 1/2".
1.6.4. If necessary, adjust rod lengths for correct operation. Remove traveler after adjustment.
2
Install cylinder.
Install cylinder. If required, cut cylinder
tailpiece as shown. Heads of cylinder
mounting bolts must be flush with door surface.
3
Install pinion cam and traveler.
3.1. With cylinder locked and key removed, install cylinder bushing and pinion cam (Figure 3-1).
3.2. Install traveler over rod ends (Figure 3-2).
Cylinder
bushing
Pinion
cam
Position flat spots on
pinion cam as shown
!
NOTE
Apply a light coating of
Duralub or equivalent
lubricant to prolong
pinion cam life.
Figure 3-1
Tailpiece
Traveler
Figure 3-2
4270101871 Revision 2 Page 3 of 8
3/64"
15/64" dia. drill
5/16" dia. c'sink
3/16" from end of cylinder
tailpiece to surface of door