Canon CanoScan 3200F Manuel de démarrage rapide - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Canon CanoScan 3200F. Canon CanoScan 3200F 20 pages. Canon scanner manual canoscan 3200, canoscan 3200f

Imprimer la page

Using the USB 2.0 Interface

To Switch to USB 2.0

If your computer is equipped with USB 1.1, you can switch to the USB 2.0 environment for faster scanning

by purchasing and installing one of the USB 2.0 expansion cards available on the market.

Compatible USB Expansion Cards/Hubs

Please use one the following USB expansion cards/hubs that have been verified by Canon for compatibility.

Expansion Cards

• Adaptec USB2connect 5100: PCI bus

• Adaptec USB2connect 3100: PCI bus

• Adaptec USB2connect 2000LP: PCI bus

• Adaptec DuoConnect: PCI bus

Hubs

• Adaptec XHUB4

• Adaptec XHUB4PLUS

• Adaptec XHUB7PLUS

For installation procedures, please read the instructions that accompany the USB expansion card/hub.

Confirming the USB Version

Use the following procedures to confirm whether your computer is

equipped with a USB version 1.1 or 2.0 interface.

Start ScanGear CS.

Click the information icon

ScanGear CS window.

Read the contents of the Interface category in the displayed

window. USB 1.1 will show as "USB 1.1" and USB 2.0 as "USB 2.0."

Click the close box

Troubleshooting the USB2.0 Hi-Speed Interface

If the scanner is not operating correctly via the USB2.0 Hi-Speed interface, follow the steps below to

troubleshoot it.

Ensure that you use the USB cable supplied with the scanner.

Connect the scanner directly to a USB port on the computer, not through a USB hub.

With the Microsoft USB 2.0 driver, if the scanner is not recognized by the computer

after installing ScanGear CS:

• Detach the AC adapter and attach it again.

• Detach the USB cable and attach it again.

Use the following procedures to confirm that the computer correctly recognizes the

USB expansion card and the scanner.

1. Open the Windows [Device Manager] and confirm that your scanner name appears below the [Imag-

ing Device] category.

2. Confirm that [Adaptec AUA-xxxx], [NEC PCI to USB Enhanced Host Controller] or [Intel PCI to USB

Enhanced Host Controller] appears below the [USB (Universal Serial Bus) Controllers] category.

3. Confirm that the USB expansion card is correctly installed into the computer and that the scanner is

attached to its port.

4. If you use more than two devices via USB2.0 Hi-Speed interface, try to disconnect other devices than

the scanner.

in the upper portion of the

to close the window.

Using the USB 2.0 Interface (On Windows)

(On Windows)