Doran 2200B Manuel de l'opérateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Doran 2200B. Doran 2200B 15 pages.

Toggle Gross and Net Modes

The GROSS / NET pushbutton is use to switch the display mode between the gross

weight and net weight. If a tare value has been entered, then the net value is the gross

weight less the tare weight.

The net mode is indicated on the display with the NET annunciator.

If a tare is not

currently stored, the display remains in gross mode when the GROSS / NET pushbutton

is pressed.

Press the UNITS button to scroll through all available weight units. The corresponding

weight units annunciator will be lit.

The UNITS button can be configured to allow the selection of any combination of units

listed above, preventing accidental selection of undesired units. See the Units

Conversion Setup Parameter for details.

The UNITS button has a parameter located in the Push Button Function Setup, which

can disable the UNITS button, and control the startup units selection every time the

scale is turned on.

Wait for the scale to become stable. Press the PRINT button to send data to a printer or

other external devices. To confirm data transmission, the left most display digit will

momentarily display an r.

The PRINT button transmits data through the standard RS-232 port, as well as the

optional RS-485, USB, Ethernet and Wireless Ethernet communication protocols.

The indicator is equipped with a Print on Demand parameter, which saves the PRINT

push button command and transmits data upon the next stable reading. This option may

be activated during the scale setup procedure. The indicator also has several automatic

print options. See the Data Communication Section in the Instruction Manual for details

on Further configuration.

Press and hold the PRINT button for 3 seconds to access the Data Output Formats for

both serial ports. Press UNITS button to toggle between the Data Output Formats for

serial Port 1 "For." and serial Port 2 "Fo2.". Use ZERO button to change the output

format setting. Press PRINT or ENTER to saved and exit this mode. The display will

show SAVEd to indicate changes were made to the Output Format setting.