Flying Gadgets F-Series 2.4G Manuel d'instruction - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Flying Gadgets F-Series 2.4G. Flying Gadgets F-Series 2.4G 7 pages. 4ch digital proportional r/c helicopter model
Également pour Flying Gadgets F-Series 2.4G : Manuel d'instruction (7 pages)
Imprimer la page
When not playing with the model, please turn it off and unplug the battery cable. If you keep it connected it could discharge
itself damaging the battery.
Also take the batteries out of the remote control when not using the model for a long time.
This product comes with a battery, please pay attention to the following safety instructions:
Only use the charger provided to charge the battery.
When charging the battery: If the battery becomes too hot, then the battery is overcharged. If this is the case then stop charging
the battery. As over charging will damage the battery.
Always supervise the charging of the battery.
Do not take the battery apart.
After flying the model the battery will be hot.
Wait for about 30 minutes for the battery to cool
down before recharging.
If you are planning on leaving the model for sometime and not
using it. Then charge it for about 1 hour before storing it away.
Preparation for flight
1. Insert the battery plug into the socket located on the right side of the
helicopter, the indicator light of the helicopter will flash rapidly, then place the helicopter
down on to a flat stable platform.
2. Slide the power switch to the "ON" position on the remote control. To activate the remote control
slowly push the throttle stick up to the top and then down to the bottom. The indicator light will flash
rapidly while the remote control is sending out the connectional signal.
3. When the auto signal connection process is finished and both the indicator light on the helicopter
and transmitter does not blink and remains lit, then push the throttle stick up slowly and then the
helicopter will take off.
1.User may push either of the control sticks to skip the auto signal connection process once the
helicopter has a connection.
2.Follow the connection tip precisely in order.
3.Once the transmitter is turned off, the connection procedure must be repeated again to
reconnect the helicopter.
Flight adjustment
1.Adjusting the swash plate:
Insert the battery plug into the power socket on the helicopter and set the helicopter down on to a
flat stable platform. When the transmitter and helicopter are connected, the
indicator light will remain "ON" without blinking. Check the swash plate if it is not
horizontal, adjust the length of the servo connector, until the swash
plate is horizontal.
OPERATIONAL TIPS