Canon imageFORMULA DR-2010M Workgroup Scanner Manuel de référence - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} Canon imageFORMULA DR-2010M Workgroup Scanner. Canon imageFORMULA DR-2010M Workgroup Scanner 36 pages. Mac os x
Également pour Canon imageFORMULA DR-2010M Workgroup Scanner : Brochure & Specs (33 pages)

Imprimer la page

IMPORTANT

• Before you place a document, check to make sure it does not

contain paper clips, staples, or other small metal objects. These

items may cause a fire or electrical shock, damage the document,

or cause a paper jam or scanner malfunction.

• Do not wear loose clothing or jewelry that may get caught in the

scanner while you are using it. This may result in personal injury. Be

extra careful of neckties and long hair. If anything gets caught in the

scanner, immediately turn OFF the power switch, and disconnect

the power cord from the power outlet to stop scanning.

• Always smooth out any folds or curls in your documents before

placing them into the feeder. If the leading edge of a document is

curled, it may cause a paper jam.

• If feeding stops due to a system error or paper jam while the

scanner is scanning, resolve the problem, make sure that the

scanned image of the last page that was successfully fed has been

stored, and then resume scanning the remaining document pages.

• After you finish scanning, close the document feed tray and the

document eject tray to prevent damage to the scanner while it is not

being used.

Placing Documents in Bypass Mode

When placing documents one sheet at a time or when placing

documents consisting of multiple pages that are attached (e.g.

invoices), set the feed selection lever to

be fed without page separation, regardless of whether there are

multiple pages.

IMPORTANT

When scanning invoices or other multi-page documents that are

fastened together, place the documents so that the edge that is

fastened together is facing down.

(Bypass). Documents will

Placing Cards

When placing cards that are thicker than standard documents, be sure

to perform the following.

● Set the feed selection lever to

● Place the card horizontally, with the reverse side facing you, and the

top of the card facing down. Up to three cards can be fed at one

time.

IMPORTANT

Always place cards horizontally. Placing a card vertically may wear

the card or result in feeding errors. In addition, cards that get jammed

may be damaged when you remove them.

(Bypass).