Coiltek CS-5000 V2 Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Coiltek CS-5000 V2. Coiltek CS-5000 V2 20 pages.

Standard Configuration and Options

The CS-5000 V2 is, as the name suggests, a revision of a product Coiltek has made since 1994. The

latest version of the control (main) circuit board operates on 24VDC. This is a common industrial

standard voltage source. Since our older cards operated on either 115 or 230 VAC, our standard

configuration of the main board includes a small, 0.8W power supply, as shown below. The supply

accepts any AC power source between 90 and 240VAC. The supply requires only L1 and L2. Connect

incoming ground to the subpanel or enclosure.

The CS-5000 may be ordered without the supply (-LPS) when a 24VDC source of sufficient amperage

is available.

There are two vertical post sizes: 54" (~1.4M) and 72" (~1.8M). From the post, a boom or arm extends

out horizontally with the sensor. This way, the sensor is located over the slack loop. There are 9 arm

lengths available: 11" (290mm), 15" (380mm), 21" (533mm), 25" (635mm), 30" (762mm), 36" (91

cm), 39" (99 cm), 45" (114 cm) and 48" (1220 cm). Systems are specified as follows:

CS-5000-xxyy

Where xx= post height, yy = arm length.

The CS-5000 may also be ordered with an M12 connector termination.