Akw M17 DigiPump Instructions d'installation et d'entretien - Page 9

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et d'entretien pour {nom_de_la_catégorie} Akw M17 DigiPump. Akw M17 DigiPump 20 pages. Digipump

Imprimer la page

Fitting Flow Sensor(s)

Depending on the installation install 1 or 2 filters and sensors to the shower water feed. Install the filter

(Y-Pattern filter) in the correct flow orientation to the shower water supply line and then fit the flow sensor

between the filter and the shower.

Confirm shower water supply pipework is flushed before connecting to the shower sensor via the filter.

Electric showers have one water supply line, cold water. Fit one Filter and Flow Sensor to this line.

Mixer showers have two supply lines, hot and cold water. Fit one Filter and Flow Sensor to each supply line.

Double check direction of the flow arrow moulded on the sensor casing is in the correct orientation with

the flow of water. Allow enough distance so that the sensors are easily accessible. Ensure all cable

connections are accessible and in a dry location. Fit sensor using an approved liquid based thread sealant

suitable for nylon threads. Connect the sensor tail cable from the flow sensor to the pump sensor cable

(see page 11). Do not tile over the flow sensors and filters and ensure they are accessible for service

and maintenance purposes.

Vertical Water Feed Installation

Flow

Direction

Flow

Direction

Horizontal Water Feed Installation

Filter in wrong orientation

Filter in correct orientation

Filter

Correct orientation

Flow

Sensor

Shower

Sensor

Tail

Flow Sensor check

flow direction

Flow Direction

Wrong orientation

Sensor

Pump Sensor Cable

Tail

Flow

Direction

Check flow sensor direction.

Pump Sensor

Cable

Shower