Ametek Gemco 1950-1 Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Ametek Gemco 1950-1. Ametek Gemco 1950-1 6 pages. Micro-adjust rotating cam limit switches

Imprimer la page

SUGGESTED SET-UP PROCEDURE

The Gemco Micro-Adjust Cams may be adjusted either

before or after installation. The following procedure is

recommended for cam adjustment.

1. Mount the assembly and couple shaft driving member

with the shaft keyway aligned with the positioning arrow

located on the bearing end plate. The machine should be

in the start cycle position with all cams set at zero.

2. Turn cam adjustment disc to the desired setting,

observing the angular degree position markings on the

top of the cam block.

3. Follow the cam setting procedure as described inside

the cover of the enclosure.

Gemco

DESCRIPTION

The Gemco Rotating Cam Limit Switch has been

developed to meet all requirements for an industrial

multipurpose cam-actuated limit switch in applications

where precise repetitive sequential, automatic, or semi-

automatic operations are required in control circuitry.

When motion is expressed in shaft rotation, either

through a roller chain, gear train, or directly, the Gemco

Rotating Cam Limit Switch makes it possible to open or

close independent circuits at any desired angular position

of the input shaft. Any closed circuit or open circuit from

4° to 356° is obtainable without the use of special cams.

All cam settings can be adjusted at any angular position

of the cam shaft.

MAINTENANCE & INSTALLATION

Lifetime sealed ball bearings provide smooth

maintenance-free operation and allow mounting of the

Gemco Micro-Adjust Rotating Cam Limit Switch in any

position.

NO TOOLS NECESSARY!

TO ADJUST CAM SETTING

Section 1980S