Canon Microfilm Scanner 500 Manuel d'instruction - Page 33

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Canon Microfilm Scanner 500. Canon Microfilm Scanner 500 48 pages.

Imprimer la page

Canon Microfilm Scanner 500 Manuel d'instruction

Code

20 21 22 23 24 25 26 27 28 29 2A 2B 2C 2D 2E 2F

Char

Code

30 31 32 33 34 35 36 37 38 39 3A 3B 3C 3D 3E 3F

Char

Code

40 41 42 43 44 45 46 47 48 49 4A 4B 4C 4D 4E 4F 50 51 52 53 54 55 56 57 58 59 5A

Char

Code

60 61 62 63 64 65 66 67 68 69 6A 6B 6C 6D 6E 6F 70 71 72 73 74 75 76 77 78 79 7A

Char

Code

5B 5C 5D 5E 5F 7B 7C 7D 7E 7F

Char

[

]

–

{

Entering the note

The procedure below explains how to enter a note. The MS500

stores the note in non-volatile memory, so that is retained even

while power is off.

The following table shows the characters that you can use for your

note. You select each character by inputting the corresponding

code value.

(

)

;

}

1. Hold down the NOTE key for about 5 seconds. The Note lamp,

Print Density display, and Print display begin blinking, indicating

that you can now enter the note.

2. Check that only the first (leftmost) Print Density display lamp is

blinking. Then press the plus or minus key until the code value

for the first letter of your note appears in the Print Density display

area. Refer to the code table above for the code/letter correspon-

dence.

To select the letter A, for example, you would enter the code value

41.

3. Press the right arrow Print Density Adjustment key once to move

to the second letter of the note. Enter the letter code for the second

letter, again using the minus or plus key.

4. Continue as described above until you have entered all the letters

for your note. Use the right arrow or left arrow to move forward

or backward in the note, and minus and plus to enter the letter

codes.

■ The note cannot contain more than 33 characters, including spaces.

■ The Print Density display shows your current location within the

note, as described below.

5. When you have finished entering the note, press the Reset key to

store it. The MS500 writes the note into memory and returns to

normal operating mode.

SPECIAL FEATURES

Code 20 selects the "space" character.