Flying Tech G-Force250 Manuel d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Flying Tech G-Force250. Flying Tech G-Force250 17 pages. Fpv racing drone kit
Imprimer la page1. Remove the Naze FC and the OSD module
from the header connections on the PDB.
3. Solder the 5 and 12 volt BECs to the PDB, taking note of their orientation and position. It's very
important that the BECs have a good contact with the PDB, so make sure you get a good flow of
solder around the joints. Next solder the XT60 power wire to the PDB. At this stage, it's a good
idea to test that the BECs are working. Ensure that the LED switch is in the 'on' position and plug in
your battery. If the 12V BEC is working, the LEDs will light up. To test the 5V BEC, use a multimeter
to measure the voltage output from the 5V auxiliary power point (located near connection S2).
Assembly Guide
2. Solder the buzzer to the PDB, taking note of
the correct polarity.