AIR GUARD AG-800 Manuel de l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AIR GUARD AG-800. AIR GUARD AG-800 8 pages.
Imprimer la page
AG-800 Description
Wireless receiver
Setup
Unpack and carefully remove all packing gaskets, especially the part of the machine nozzle.
§
Place the machine on a flat surface with at least 50 cm of space around the machine.
§
Remove the lid of the disinfectant container of the device, add Air Guard disinfectant FLD-05 to the
§
80% and carefully cover the cap。
Please use Air Guard Disinfectant FLD-05. The use of other liquids will not only invalidate the
§
disinfection effect, but also cause machine blockage and damage。
Operation
Do not overfill the tank when adding disinfectant solution, and remember to tighten the cap.
§
After that, please insert the power plug into the socket and turn on the power switch on the back of
§
the machine. Connect the machine to a power source. Before connecting, please confirm whether
the required power indicated on the technical label of the machine is consistent with the power
supply.
When the power is connected, the machine will start to heat up. Please note that the preheating
machine cannot output smoke, and the orange LED light on the handle of the AG-800 machine will
continue to flash until the machine is heated up.
Power switch
M22 Moisture Co., Ltd.
Tel.+886 3 3225829 – Fax +886 3 3220433
www.airguard.com.tw
e-mail:[email protected]
Fluid tank
Power switch
Fuse