Astrol Electronic BAT-FLEX Manuel - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Astrol Electronic BAT-FLEX. Astrol Electronic BAT-FLEX 19 pages.

5. Measurement-Program Example

There is an example file on the CD with the name test.mpr. This file can be opened with the CCCC-Tool. This file contains only the

program flow which describes the measurement behavior. The recorded data are saved in a separate file with the ending *.dat.

The following chapter explains the example file test.mpr

which contains a program for 100 GS-cycles from 2.7-3.4V

with 10mA.

If the file is opened with CCCC-Tool there is a window with all

program steps listed. Every step has a unique number which

acts as a reference for conditional jumps from other steps.

The first step is a counter step which sets the cycle counter

to one.

The following two steps are galvanostatic-steps which

charge/discharge with a constant current until the defined

end voltage is reached. With the reduction condition the

voltage is being held constant until the current drops below

the defined current limit of 1mA.

After these two cycles a counter step increases the counter

and jumps to the next charge step if the cycle counter hasn't

reached the limit of 100 cycles.

At the end there is a charge cycle to charge the cell to a specific charge condition for storage.In the GS-Step window there are many

options available. The important ones are the charge current and the reduction condition where one can choose the measurement

source.

Astrol Electronic AG reserves the right to change specifications without notice

Bat FLEX Manual

In the conditions table multiple conditions on which the step

needs to stop or jump to a predefined step number can be

defined.

After saving the program one can proceed with the

measurement and data analysis.

14/19

AD-10069-007 Rev. 03