Cole Hersee 24505 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cole Hersee 24505. Cole Hersee 24505 2 pages. Lockout lever kit for master disconnect switch

Imprimer la page

Lockout Lever Kit for

Master Disconnect Switch

24505

for 5/16" shackle locks

24505-01

for 7mm shackle locks

This kit may be used with all Cole Hersee

metal

lever-activated

Switches with a 3/4 diameter mounting stem

Use this kit to secure the switch in the

Off position with a padlock.

lockout procedures may be required by

regulations, particularly in situations

where

moving

accidentally turned on causing risk of

injury.

In Package

Locking Lever

•

Bracket

•

10-32x3/8" Screws (2)

•

Installation

1. Make sure that the switch is in the off position

Warning

— Disconnect all battery cables from

the battery before attempting to install this

product

3. Remove the lever from the switch. Retain the

existing screw and lock washer as these are

required to attach the locking handle

4. Remove the hex nut and lock washer from the

mounting stem

5. Place the bracket over the stem

6. Replace hex nut on mounting stem and tighten

only finger tight

7. Put The locking handle on the switch and

replace lock washer and screw from original

lever. Tighten finger tight

8. Rotate bracket until the hole in handle lines up

with the hole in the bracket.

9. Mark the center of the mounting screw holes

IF-153

Rev. B

master

Disconnect

machinery

might

Such

Notch for

Anti-Rotation

Indexing Pin

Stud

10. Remove the handle with screw and lock washer

OFF

Hole for Switch

Mounting Stem

Mounting Screw

Holes