Air Hogs Zipper Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Air Hogs Zipper. Air Hogs Zipper 4 pages.

Imprimer la page

PROBLEM

Propeller won't move.

Suddenly stops and falls when flying.

The Zipper™ does not react.

Loss of control.

For further questions and problems, please visit our website www.airhogs.com.

Safety Precautions:

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

- Keep hands, hair and loose clothing away from the propeller when the power

switch is in the "ON" position.

- Turn off controller/charger and Zipper™ when not in use.

- Remove batteries from controller/charger when not in use.

- Parental guidance is recommended when flying.

- Keep your Zipper™ in your sight in order to prevent it from flying out of range.

FCC Statements

This device complies with part 15 of the FCC rules. Operation is subject to the

following two conditions: 1) This device may not cause harmful interference, and 2)

This device must accept any interference received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

Important Battery Information:

- Non-rechargeable batteries are not to be recharged

- Rechargeable batteries are to be removed from the controller/charger

before being charged (controller/charger only).

- Rechargeable batteries are only to be charged by an adult.

- Different types of batteries or new and used batteries are not to be mixed

(controller/charger only).

- Only batteries of the same or equivalent type as recommended are

to be used.

- Batteries are to be inserted with correct polarity.

- Exhausted batteries are to be removed from the controller/charger.

- The supply terminals are not to be short-circuited.

- Do not mix old and new batteries (controller/charger only).

- Do not mix alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium) batteries (controller/charger only).

Zipper™ is equipped with a Li-Poly rechargeable battery, please also

pay attention to the following cautions for safe use:

- Do not dispose of the battery in fire or heat.

- Do not use or leave the battery near a heat source such as a fire

or heater.

- Do not strike or throw the battery against a hard surface.

- Do not immerse the battery in water, and keep the battery in a cool dry

environment.

- When recharging, only use the battery charger specifically for that

purpose.

- Do not over-discharge the battery.

- Do not connect the battery to an electrical outlet.

- Do not directly solder the battery and pierce the battery with a nail or other

sharp object.

- Do not transport or store the battery together with metal objects such as

necklaces, hairpins etc.

- Do not disassemble or alter the battery.

- Charge the battery every 6 months.

- Turn off your equipment power switch after use.

- As for a used battery, please recycle after covering the battery terminals

with insulation tape or inserting it into an individual poly-bag.

Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada

Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221, USA

Spin Master Toys Far East Limited. Rm #1113, 11/F, Chinachem Golden Plaza, 77 Mody Rd.,

Tsimshatsui E., Kowloon, HK

Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks, SL8 5AJ,

United Kingdom

Spin Master France – 36 rue de Silly – 92100 Boulogne Billancourt – France

North American Consumer Information

Phone: 1-800-622-8339

www.spinmaster.com

TROUBLESHOOTING

CAUSE

- ON/OFF Switch is OFF.

- Weak Battery.

- Weak power.

- Channel selection on controller/charger

is not correct.

- Another infrared control (IR) device is

using the same channel.

- Affected by strong light.

- New and alkaline batteries are recommended for use in controller/charger to

obtain maximum performance.

- You are advised to replace with new batteries as soon as the function becomes

impaired.

- Users should keep and retain this information for future reference.

- Users should keep strict accordance with the instruction manual while operation

the product.

- Your controller/charger is tailor-made for the Li-Poly rechargeable battery used in the

Zipper™. Do not use it to charge any other battery other than that in the Zipper™.

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Care and Maintenance:

- Always remove batteries from the toy when it is not being used for a long

period of time (controller/charger only).

- Wipe the toy gently with a clean damp cloth.

- Keep the toy away from direct heat.

- Do not submerge the toy in water, this can damage the electronic

assemblies.

Note:

- Parental guidance is recommended when installing or replacing batteries.

- If in an environment with electrostatic discharge, the sample may

malfunction and require user to reset the sample.

Special Note to Adults:

- Regularly examine for damage to the plug, enclosure and other parts. In

the event of any damage, the toy must not be used with the

controller/charger until the damage has been repaired.

- This toy is not intended for children under 3 years old.

- This toy must only be used with the recommended controller/charger.

- Do not try to charge other batteries with the controller/charger.

Battery requirement for Zipper™:

- Set switch to ON.

- Re-charge the battery pack.

- Set to the correct channel.

- Avoid these if possible, or choose another

place to fly the Zipper™.

- Choose an area that's not as bright.

Power Supply :

Rating

: DC 3.7 V, 3,33 W

Batteries

: 1 x 3.7 V Li-Poly Rechargeable Battery Pack

(included)

Battery requirement for Controller/charger:

Power Supply :

Rating

: DC 6 V, 1,2 W

Batteries

: 4 x 1.5 V "AA"/LR6/AM3 (not included)

Conforms to product safety standards ASTM F963,

regulatory requirements. Products and colours may vary.

Please retain this information for future reference.

Patent Pending. MADE IN CHINA.

20020527, 20020528, 20020529

NEN REV 0

SOLUTION