Daedong Kioti Instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Daedong Kioti. Daedong Kioti 3 pages. 1600xdr-2, k92400-eu, k92400-la, k92400d-au, xs2000

Imprimer la page

2. GENERAL SAfETy INfORmATION

This symbol means ATTENTION!

yOUR SAfETy IS INVOLVED.

The message that follows the sym-

bol contains important information

about safety. Carefully read the mes-

sage.

BEfORE SERVICING AND REPAIRING

. Read all safety instruction in this manual and

be aware of safety decal locations on your

machine.

2. Thoroughly clean your work area and the

machine.

3. Make sure the machine is on ﬁrm and level

ground and that the parking brake is set.

4. Lower the implement to the ground.

5. Stop the engine and remove the key.

6. Disconnect the negative battery cable.

7. Place a "DO NOT OPERATE" tag in the

operator station.

WORKING SAfETy

. Do not operate or service the machine while

under the inﬂuence of alcohol, medications,

or other sustances.

2. Never wear loose ﬁtting clothing and always

use safety equipment appropriate to the job.

3. N e v e r u s e i m p r o v i s e d t o o l s, p a r t s o r

procedures. Use only recommended tools

appropriate to the work.

4. Extra care should be taken to work safely

when servicing is done by two or more

persons.

5. Always support the machine with safety

stands rated for the weight of the machine.

N e v e r w o r k u n d e r a m a c h i n e t h a t i s

supported solely with a jack.

6. Do not touch any rotating or hot parts while

the engine is running.

7. Escaping ﬂuid (hydraulic oil) under pressure

can penetrate the skin causing serious

injury. Relieve pressure before disconnecting

hydraulic or fuel lines. Tighten all connections

before applying pressure.

DISPOSE Of fLUIDS PROPERLy

. Observe relevant environmental protection

regulations when disposing of oil. NEVER

pour ﬂuids onto the ground, down a drain, or

into any body of water.

3. INSTALLATION INSTRUCTION

. Park the vehicle on firm and level ground.

Then, engage the parking brake and stop the

engine.

2. Unscrew the seat mounting bolts (A) (3 EA)

from the rear frame. (Bolts should be reused)

3. Install the seatback cover (2) to the rear

frame and tighten the bolts (A, in Step 2) and

screw () (0 EA).

- 3 -

U20SA02A

U20SA03A