Doremi JNIOR 310 Installation et configuration - Page 3

Parcourez en ligne ou téléchargez le pdf Installation et configuration pour {nom_de_la_catégorie} Doremi JNIOR 310. Doremi JNIOR 310 3 pages.

Setup DCP2000 for JNIOR 310

GPI Triggers (Inputs)

Configure the GPI actions related to jnior

1) In the Macro Editor select "Trigger Cue" tab at

the bottom.

2) Create a new cue, click on the

3) Name the macro & OK

4) Click "Connect to an Event"

5) Select "Signal"

6) Leave "Any" in the "Source device name"

7) Click

to open the library of actions

8) Select "jnior" from the left, then the required

action "e.g. DIN4_ON" & OK

9) Confirm "Any" and the "Signal name" is correct

10) Click "Save" (default password is 1234)

Check the DCP2000 is register to the JNIOR

b) Open a terminal session

c) Check the log files /doremi/log/drmjniord.log

Type: tail /doremi/log/drmjniod.log

d) If device is properly registered, you will get an

entry as indicate below

e) Or generate a details log file and view

drmjniord.log

Test cues with content playback!

1) Start cinelister

"Menu->Doremi Labs Inc-Cinelister"

2) Create a new show

2) Insert any content in the show

3) Attach a GPO macros as created earlier

5) Attach a trigger cue based on the JNOIR

6) Select the action to associate with this trigger

TogglePlayPause is a macro that

toggles between play / pause!

Note: Set mode to 'Loop' if video content is short.

8) Start the playback

9) Check if the expected Macros and Trigger

Cues behaviors happened.

Menu/system/Terminal

<enter>