Canon REALiS SX80 Mark II D Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Canon REALiS SX80 Mark II D. Canon REALiS SX80 Mark II D 25 pages. Projector
Également pour Canon REALiS SX80 Mark II D : Manuel du produit (12 pages), Manuel du produit (13 pages), Brochure & Specs (12 pages), Manuel complémentaire (10 pages), Brochure & Specs (12 pages), Brochure & Specs (4 pages), Manuel du produit (18 pages), Caractéristiques (19 pages), Manuel de l'utilisateur (1 pages), Manuel du produit (10 pages), Brochure (27 pages), Questions fréquemment posées (1 pages), Spécification du produit (2 pages), Manuel de l'utilisateur (2 pages), Brochure (2 pages), Brochure (32 pages), Brochure & Specs (12 pages), Brochure & Specs (12 pages), Caractéristiques et spécifications (3 pages)

Canon REALiS SX80 Mark II D Manuel de l'utilisateur
CCCCTCC C
C1C
Introduction Crocess
Prepare for introduction of this software as shown below.
C Creparing an administrative
2 Creparing the Crojector
3 Installing the Software
4 Configuring Network
Settings of the Software
Introduction
computer
Prepare an administrative computer that is
connected to a network. Projectors connected to
the local area network can be managed.
If the network is managed under a subnet,
network settings on the administrative computer
must be configured to gain access to the target
projector. Contact the system administrator for
details.
Connect a projector for management to the
network, and configure its network settings. In
addition, you must configure the SNMP settings
of the projector when using SNMP protocol. For
procedures on configuring the projector, see the
instruction manual that came with the projector.
Install this software on to the administrative
computer.
(see p. 4, 1.3 Installing the Software)
Configure the protocol settings and the polling
interval settings for discovery.
(see p. 5, 1.4 Configuring the Network Settings
of the Software)
CHAPTER 1 • Introduction
3