daewon DIB-B850R Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} daewon DIB-B850R. daewon DIB-B850R 19 pages.

Imprimer la page

Product Installation

6. Attach the bidet seat to the catch plate

Adjust the seat and front part of the toilet back and

forth so that they can correspond before fastening

the bolts.

Set the bidet seat flat on the toilet bowl and push it

in until it clicks into place and is secure. Failure to

do may cause the seat to come apart.

7. Connect the bidet hose to the bidet seat

Rotate the water inlet backward and hand-tighten

to secure. Make sure the hose is not twisted,

excessively bend it, or strip the plastic threads when

screwing the hose onto the bidet seat.

After connection, rotate the inlet back to the normal

position.

Connect the other end of the hose to the T-valve.

Check and ensure the rubber washer is not twisted

when fastening.

※ Bidet Filter Installation

Customers with hard water, well water, and rust

water can extend the life of their bidet seat by

installing an inline water filter.

Install the filter between T-valve and bidet hose.

The bidet filter should be replaced every 4~6months.

Failure to replace the filter on time may result in

water contamination, supply congestion, or filter

breakage.

Remote Installation

비데 설치방법

1. Find a place visible and reachable from

the toilet and clean the space thoroughly

before attaching the bracket.

2. Peel the adhesive protection film and

attach the bracket on the wall.

3. Insert the batteries deeply inside first

and press the outside all the way down

to complete the insertion.

4. Gently insert the remote control into the

bracket.

5. If the automatic pairing is failed, follow

the below instructions.

Plug in the bidet seat.

The nozzle comes forward and goes backward,

then melody plays.

Insert the batteries.

Press any buttons to complete the pairing.

Melody is played to identify pairing completion.

6. Replace all batteries at the same time.

Do not mix old and new batteries.

※ Caution for pairing

Be sure to proceed in the order of pairing method. If the order is reversed during

pairing, remove the remote control batteries and product power cord, wait tens of

seconds, and start again from the beginning.

To automatically pair the remote to the seat, install the batteries into the remote within

5 minutes of plugging the seat into the power outlet.

This product is an RF-type remote control with its own unique number assigned to each

product. There is little chance of confusion if two or more remote control bidet seats are

installed at the same place. In this case, contact the local dealer where you purchase

your seat for more assistance.