bolid DIP-34SA Manuel d'instruction

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} bolid DIP-34SA. bolid DIP-34SA 2 pages. Standalone photoelectric smoke alarm
Également pour bolid DIP-34SA : Manuel d'instruction (2 pages)

Imprimer la page

STANDALONE PHOTOELECTRIC SMOKE ALARM

1.1 General

DIP-34SA Photoelectric Smoke Alarm is designed for standalone operation to detect inflammations and issue local audible and light

alarms. The DIP-34SA provides protection of closed areas by sensing smoke registering the light scattered by smoke particles. The

DIP-34A is to be used in a kitchen, near heaters in cottages and so on.

DIP-34SA generates light and high-level sound signals. The alarm indicates low-battery signals, if happened, by periodic short sound

of low intensity.

1.2 Specifications

1) Detector Sensitivity

2) Alarm Response Time

3) Consumed Current

4) Technical Readiness Time

5) Input Power

6) Operating Temperatures

7) Relative Humidity

8) Overall Dimensions

– diameter

– height

9) Weight

2.1 Mounting

To attach the smoke alarm base to the ceiling, drill two holes of 5 мм in diameter, with the distance between the centers of holes

being equal to 40–70 mm. Insert the wall plugs provided into the holes and fasten the device base to the ceiling with the woodscrews

provided.

DIP-34SA alarms are to be installed on ceilings at distances no more than 4.5 м from walls. Being installed at heights up to 3.5

m, a single DIP-34SA covers approximately 85 м².

Alarms can be combined together by a two wire line in a group up to 38 units. In such case a response of a single smoke alarm

causes other alarms from the group to sound too. The alarms are bounded by connecting wires within them. Be careful to match colors

while connecting the wires. The wires are connected to the connecting line by crimping wires in connectors provided.

2.2 Testing

The DIP-34SA smoke alarm is equipped with a latch on its enclosure in order to prevent DIP-34SA mounting without a battery.

The detector is delivered with the battery being attached under its base. Connect the battery to the terminal block before

testing DIP-34SA smoke alarm.

After battery's having been connected a sound alarm can be issued within a second. Please wait until the LED flashes that means

entering to the quiescent mode. Press TEST button and hold it pressed for about 5 second until LED flashes and sound alarm goes off.

The sound must be loud interrupted one. This means that the detector operates correctly.

Otherwise, if the test procedure failed, disconnect the battery and wait for 5 minutes before connecting this one again to repeat

testing.

If the test has been completed successfully, install the detector on the base and inspect visually periodical (approximately once

per 30 s) LED flashes confirming detector's entering normal quiescent mode.

2.3 Maintenance

Test the detector periodically by pressing TEST button until sound alarm goes off. This can take up to 20 seconds. It is the

only way to ensure that the detector operates properly.

Appearing of a periodical weak short sound signal indicates that power supply voltage has dropped and the battery must

be replaced.

3.1 The average lifetime of the smoke alarm is at least 10 years.

3.2 The manufacturers warrants its product to be free from defects in materials and workmanship under normal use and service

for 18 months since putting it into operation, but no more since 24 months since acceptance date.

3.3 In the event of in-warranty failure forward your claims to the address:

ZAO NVP Bolid

4 Pionerskaya Str., Korolev 141070, Moscow Region, Russia

Tel./Fax: +7 (495) 775-71-55, +7 (495) 516-93-72

E-mail:

[email protected]

DIP-34SA

INSTRUCTION MANUAL

1 TECH NICAL DATA

- from 0.05 to 0.2 dB/m

- 10s max

- 0.01 mA max

- 60 s max

- 9V

- from −10 to +55°С

- up to 93% at +40°С

- 102 mm max

- 35 mm max

- 0.2 kg max

2 O P ERATIO N INSTRUCTIO NS

http://www.bolid.com.

1.3 Standard Delivery

Find the following unpacking DIP-34SA:

– DIP-34SA Photoelectric Smoke Alarm

– ECT UY Connectors

– Woodscrews

– Wall Plugs

– 6F22 9v Battery

– Instruction Manual

3 WARRANTY

- 1 pc.

- 2 pcs.

- 1 pc.