Canon REALiS SX80 Mark II D Manuel complémentaire - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel complémentaire pour {nom_de_la_catégorie} Canon REALiS SX80 Mark II D. Canon REALiS SX80 Mark II D 10 pages. Projector
Également pour Canon REALiS SX80 Mark II D : Manuel du produit (12 pages), Manuel du produit (13 pages), Brochure & Specs (12 pages), Manuel de l'utilisateur (25 pages), Brochure & Specs (12 pages), Brochure & Specs (4 pages), Manuel du produit (18 pages), Caractéristiques (19 pages), Manuel de l'utilisateur (1 pages), Manuel du produit (10 pages), Brochure (27 pages), Questions fréquemment posées (1 pages), Spécification du produit (2 pages), Manuel de l'utilisateur (2 pages), Brochure (2 pages), Brochure (32 pages), Brochure & Specs (12 pages), Brochure & Specs (12 pages), Caractéristiques et spécifications (3 pages)

3. Control Flowchart

Error Response

Investigate the status in

the response table and

take measures as needed

Notes

• When sending commands in succession, wait until a response is received from the

first command before sending the next command.

• Command timeout is 10 seconds. If no response is returned within 10 seconds after a command is sent,

the command or response may not have reached the destination.

Turn off the device, check the communication cable, and resend the command.

START

Command

Transmission

Response Reception

Response

received?

YES

Has 10 seconds

elapsed?

YES

Success?

YES

First failure?

(Confirm)

Command

Transmission

No Response from Projector

◆ Confirm that the projector is on

Same response standby

◆ Check the AC cord

processing as above

◆ Check the control cable

Expected

results

obtained?

YES

END

YES