Canor Virtus M1 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Canor Virtus M1. Canor Virtus M1 6 pages. Vacuum tube power amplifier

Imprimer la page

FRONT PANEL:



POWER – turning on and off the amplifier



UL – pressing this button switches to an ultralinear mode.



TR – pressing this button switches to a triode mode.



DIMM – sets the display brightness in steps. From a turned off display to its maximum brightness.



After turning on, the display is in its middle brightness level. In state of a turned off display during

operating the device with function keys the display lights up and after a few seconds the display turns

off again.

BACK PANEL:



FUSE TUBE 1 / FUSE TUBE 4 – 5x20 T315mA



TRIGGER INPUT – input for triggering cable from preamplifier



TRIGGER OUTPUT – bypass output for triggering cable



POWER – mains power inlet / mains switch with mains fuse 5x20 T3,15A



INPUT – analogue 3pin XLR input



OUTPUT – dedicated 4 and 8 Ohm speaker terminals



ZERO FEEDBACK / FEEDBACK – enables instant switching between the connection with the

feedback or with zero global feedback.

Basic functions of reproduction

Plug the power cord in VIRTUS M1. Turn on the amplifier with the Power Main switch, which is located on the

back panel. When you turn on the main switch, the VIRTUS M1 will set into stand-by mode - the red LED diode

on the front panel lights up. After pressing the Power button on the front panel, the controlled turning-on

sequence gets initiated, which consists of cooling and preheating the tubes, thereby extending their life span. The

cooling cycle is also being carried out when the unit is turned off. If the main switch on the back panel is not

turned off, i.e. after turning off via button on the front panel, the 45-second countdown to cooling without

indication begins. If you turn on the unit at this time, the cooling will continue and will be indicated by flashing

red LED. When the cooling cycle is over then the main transformer gets connected and then the slow start-up of

voltage begins.

This cycle lasts 45 seconds and then the red LED stops flashing, an output relay connects the signal to the input

if the main power supply does not get disconnected.

You can connect both 4 and 8 Ohm loudspeakers. The amplifier has separated terminals for each type.

Guarantee conditions:

Your CANOR VIRTUS M1 power tube amplifier is guaranteed against any defect in materials and workmanship

for a period of 24 months from the date of purchase except for audio vacuum tubes that are covered by warranty

for a period of three months.

The warranty only applies if an original proof of purchase and acknowledged certificate of warranty can be

furnished. The warranty covers defects in materials and labour, but does not cover misuse, unauthorized

modifications, and external causes such as acts of nature.

European Community Directives

This product is designed and manufactured in order to comply with existing laws of the European Community.

This product is certified by testing laboratory and bears the CE mark.