Cansec Zodiac FR100 Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cansec Zodiac FR100. Cansec Zodiac FR100 15 pages.

DIODES

Diodes are required for inductive loads such as electric strikes/locks. Failure

to use appropriate diodes will void the reader warranty.

Use MARR Connectors

If you are bringing in cable that is too large for the terminal

strip, use a MARR connector (wire nut, marrette, thimble

connector, cone connector). Splice the thicker cable to a cable

that is the appropriate thickness, and then run the thinner

cable to the terminal strip on the control panel.

Use Splices for Parallel Wiring

The terminal strips are designed to allow one cable per hole.

If you need to connect multiple cables in a single hole, use a

MARR connector (wire nut, marrette, thimble connector,

cone connector). Splice multiple cables to a single cable, and

then run the single cable to the terminal strip on the control

panel.

NOTE: When determining power supply current requirements, you must consider lock

and reader current draw if using the same supply for these devices.

Installation of magnetic locks is not supported with this reader

NOTE:

NOTE: The lock must have a diode installed to prevent "back EMF" from

damaging the reader.

Zodiac FR100

Installation Manual

Page 5 of 15

June 2014 • Rev. 1.2