Bolton Tools BS-128DR Manuel d'utilisation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Bolton Tools BS-128DR. Bolton Tools BS-128DR 16 pages. Horizontal and vertical metal cutting band saw

Imprimer la page
1. Know your bandsaw. Read the operator's Manual carefully. Learn the
operations, applications and limitation as well as the specific potential
hazards peculiar to this band saw.
2. This unit is equipped with a three-prong (grounded) plug for your
protection against shock hazards and should be plugged directly into a
property grounded three-prong receptacle. Where a two-prong wall
receptacle is encountered. It must be replaced with a properly
grounded three prong receptacle in accordance with the
3. Use only 3-wire extension cords, which have 3-prong grounding type
plugs.
4. Replace or repair damage or worn cord immediately.
5. Keep guards in place and in working order.
6. Be especially careful when using bank saw in vertical position to keep
fingers and hands out of path of path of blade.
7. Wear ear protection if exposed to long periods of very noisy shop
operations.
8. Use safety goggles, hard hat and safety shoes. Also use face or dust
mask if cutting operation is dusty.
9. Wear proper apparel. No loose clothing or jewelry to get caught in
moving parts. Do not wear a tie or gloves.
10. Don't overreach. Keep your proper footing and balance at all times.
11. Secure work. Always use the vise to hold work. Clamp securely. Never
hand-hold the work with saw in horizontal position.
12. Keep work area clean. Cluttered areas and benches invite accidents.
13. Avoid dangerous environment. Don not use the band saw in damp or
wet location. Keep work area well illuminated.
14. Don't force tool. It will do the job better and safer at in the rate for
which it was designed.
15. Disconnect power cord before adjusting and servicing and before
changing blade.
16. Safety is combination of operator common sense and alertness at all
times when the saw is being used.
17. Never stand on tool. Serious injury could occur if the tool is tipped or if
the cutting tool is accidentally contacted.
18. Check damaged parts. Before further use of the tools, a guard or other
parts that it will operate to assure that it will operate properly
19. and perform its intend function-check for alignment of moving parts;
binding of moving parts, breakage of parts, mounting and any other
SAFETY