Battery Brain IV RV Series Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Battery Brain IV RV Series. Battery Brain IV RV Series 12 pages.

Imprimer la page

STEP 4: Install Black Engine On Wire

Installation of the Engine On wire will prevent

the Battery Brain from disconnecting the battery

while the engine is running. This will also

prevent the Battery Brain from disconnecting

the battery if the voltage level drops below

11 .8V as could be the case with accessories

that briefly reduce the voltage below the

threshold level or in the case of problems with

the vehicle electrical components. i.e.: bad

alternator.

This wire must be installed to ensure the

Battery Brain will not activate while the engine

is running.

*Not required if optional Vibration Sensor is

used. (Purchased separately).

A) Locate a wire or fuse that has 12V when the

ignition switch is in the "ON" or "RUN" position

and is OV when the ignition switch is in the

"OFF" position.

B) Slide the connector end of the black engine

on wire onto the single connector on the

Battery Brain that is labeled with "ACC".

C) Attach the other end of the supplied black

engine on wire to the selected wire or fuse

as located in step A above. This may require

running a wire to the interior of the vehicle.

A fuse-tap or wire-tap connection may be

required.

STEP 5: Red Accessory Bypass Wire

Installation [Optional]

Installation of the red accessory bypass wire

will provide you with continuous 12V power

to an accessory or accessories bypassing the

Battery Brain designed to allow you to save

presets or memory settings.

NOTE: Use of this feature will bypass the

Battery Brain and may allow the battery voltage

to drop below the minimum charge needed to

start your vehicle.

NOTE: Exact location of the fuse & fuse panel

will differ by manufacturer; consult your owner's

manual or wiring schematic for the vehicle to

locate fuses for the accessories. Amperage for the

bypassed accessory must not exceed 7.5Amps.

A) Locate the fuse that provides power only to

the accessory that you wish to have it active at

all times.

B) Attach the exposed end of the red bypass

wire to the fuse or device you wish to have

active on the non active side of the fuse. A fuse

tap connection may be required.

C) Carefully route the wire from the fuse to the

Battery Brain. A fuse-tap or wire-tap connection

may be required.

D) Attach the connector end of the red bypass

wire onto the butterfly connector on the female

positive post of the Battery Brain.