al dente DUNAFORM Manuel d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} al dente DUNAFORM. al dente DUNAFORM 8 pages. Pressure thermo-forming unit for foil 120 mm and 125 mm
Imprimer la page
8. EXCHANGE OF FUSES
• Mains supply cable from the female connector installed (14).
• Open at the indentation the cover of the fuse carrier (15) by means of a screwdriver (size 1) and pull it out.
• Exchange the defect fuse. Attention: Only use fuses as indicated besides the fuse carrier: T 4 A.
• Put the fuse carrier (15) back into the female connector installed (14).
• Connect mains supply cable to the female connector installed (14).
Swivel the pressure chamber (9) below the heating cap (3). The process
initiated by the operator is shown on the display (4).
If the foil gets severely heated (visible by an immense flexion of the foil), the
heating time can be cancelled by pressing the button (7) „Enter" and the
operation can be proceeded as described further below.
After termination of the thermoforming procedure, the heating time necessary
can be recorded by pressing the button „ Enter" again.
Cover for granules (21) available as accessory, item no. 581-004-035
On termination of the heating time swivel the pressure chamber (9) all
the way off the heating cap (3).
Put the pressure chamber (9) over the model and lock it by means of
turning the closing device (12) clockwise.
The process initiated by the operator is shown on the display (4).
On termination of the cooling down time unlock the pressure chamber (9)
by means of turning the closing device (12) counter-clockwise and in doing
so press from above onto the pressure chamber.
Lift off the pressure chamber (9) and swivel it for 180° all the way. Turn the foil
tension ring (1) counter-clockwise all the way and take it out.
Take out the thermo-formed result (20).
The fuses are situated in the female connector installed (14) at the back of the
unit.
The fuse is to be exchanged as follows:
7