Dot Origin VTAP50 Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dot Origin VTAP50. Dot Origin VTAP50 16 pages. Oem module

4.4 Antennas

The VTAP50 OEM module has been tested with its integrated loop antenna, printed on the

PCB. There are no alternative antennas approved for use. The VTAP50 OEM module is

designed so that you can carefully break the integrated antenna from the board and connect

an external antenna. If an external antenna is attached, the new arrangement would require a

new FCC approval.

When FCC approval for the VTAP50 OEM module has been obtained, the integrator must

attach a label to the new equipment, hosting the VTAP50 OEM module, with specific text

required by the FCC. Please contact us for this information when needed.

The following test modes are recommended to achieve states of maximum emission levels or

susceptibility in the VTAP50 OEM module:

1. VTAP50 OEM module powered on. Communicating with PC over USB. Continuously

reading tag.

2. VTAP50 OEM module powered on and tag present, but not communicating with external

device.

The VTAP50 OEM module will only be FCC authorised for use in compliance with the specific

FCC transmitter rules listed on the grant. The integrator is responsible for compliance to any

other FCC rules that apply to the host, which are not covered by the modular transmitter

grant of certification.

The final host product, with the VTAP50 OEM module installed, will still require Part 15

Subpart B compliance testing, to evaluate transmission effects when the VTAP50

OEM module and host equipment operate at the same time. Be aware that additional

testing can be required on the final integrated system. We recommend integrators refer to

further advice from the FCC OET Knowledge Base, such as 996369 D04 Module

Integration Guide v02.

VTAP50 OEM MODULE INSTALLATION GUIDE

PAGE 9