Dot-x DNR V SERIES Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dot-x DNR V SERIES. Dot-x DNR V SERIES 10 pages. 25 inch display
Également pour Dot-x DNR V SERIES : Manuel de l'utilisateur (12 pages)

Imprimer la page
INDEX
AVAILABLE MENUS
BASIC MENU OPERATION
CHANGING SECURITY CODE AND UNIT NUMBER
CHECKING REVISION LEVEL
CUSTOM OPTIONS

GETTING STARTED

INTRODUCTION
JUMPER LOCATIONS
LOST OR FORGOTTEN SECURITY CODE
MENU - AVAILABLE
MENU - BASIC OPERATION
MENU - HARC
MENU - INSTALLERS
MENU - TO ACTIVATE
PRECAUTIONS
REMOTE CONTROL PICTORIAL
SECURITY CODE - CHANGING
SECURITY CODE - LOST
SERVICE PACK CONTENTS
TO ACTIVATE MENUS AND CONTROLS
WARRANTY
18
INTRODUCTION
Congratulations on your purchase of a new DNR V Series with HARC
7
(Handheld Addressable Remote Control) option.
7
13
This manual has been prepared to act as a guide in the operation of your unit
16
when the HARC option is installed. Please read the following operating
15
instructions carefully before using your unit so that you are familiar with all of
3
its features and capabilities. All precautions and safety warnings should be
3
read and strictly observed.
17
17
SERVICE PACK CONTENTS
7
7
The service pack consists of the following:
13
8
•
4
2
•
6
13
•
17
3
•
4
19
GETTING STARTED
Refer to the monitor manual for connecting power and signal to the monitor.
For initial operation of multiple unit installations, apply power to only one unit
at a time, while changing the unit identification number (Unit ID) from the
factory set 01 to a sequence of unique numbers for each unit.
Unpack the remote control and install batteries.
The DNR V with HARC responds to remote control inputs in a manner similar
to many other remote control devices including TVs, VCRS etc. with two
important differences. First, a security code is required before access to any
menus is allowed. Second, a unit selection number is required to select one
unit from a group of several units, allowing individual adjustments to individual
units with one remote control.
Until the security code and unit selection numbers are entered, the
monitor will not respond to the remote control.
Storage Bag
Remote Control
2 AA Batteries
This Manual
3