Dotco 15LN254 Manuel des pièces détachées - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel des pièces détachées pour {nom_de_la_catégorie} Dotco 15LN254. Dotco 15LN254 16 pages. Right angle drills 15ls series; 15ln series; 15ss series; 15sn series
Imprimer la page
PL31--15LS2
02/00
1006205 Retaining Nut
•
1009087 Ball Bearing
(
=
) NOTE: ALWAYS replace Bevel
Gear and Output Spindle IN PAIRS
since both should wear equally.
1019759 Spanner Wrench (service
wrench not supplied with angle
head assembly).
Fits #1019569 Bearing Cap
3/8" Hex
LUBRICATION
Only Molykote is recommended for use in these angle heads.
Wipe on only a small amount and remove any excess.
REASSEMBLY (With new components)
1. Start with only one 0.002" shim (part #1006265) above work
spindle in bearing pocket. Assemble all output spindle
components, applying Molykote, and tighten bearing cap to 15
inch--pounds torque.
This is for end play only. With too much play, take out the
0.003" shim. A slight back--and--forth amount of play is
acceptable and necessary.
2. Assemble all remaining components and check gear
"shake". This is for gear mesh which should be no more than
0.005".
3. Be sure to apply Molykote before assembly.
DOTCO
Models 15LS & 15LN Angle Drills
90º Miniature Angle Heads
1009643 Spindle Extension
•
1019559 Ball Bearing
•
=
1019555 Bevel Gear
LH Thread
Assembly
Angle Head
Includes
Assembly
Output Spindle
Part Number
Part Number
1025314
1019553
1025409
1019551
1025313
1019552
1025328
1019554
1008748 Shim — 0.002"
1013224 Shim — 0.005"
1019556 Angle Head
(Includes #1008992
Grease Fitting)
1"--20
•
1019559 Ball Bearing
•
1019560 Ball Bearing
(
one (1) or one set for every 6--10 tools. Small,
easily lost or low cost parts should also be
ordered on the basis of 3--4 per 10 tools.
Page 10
Spindle
Thread Size
(Internal)
#10--32
1/4"--28
9/32"--40
5/16"--24
As
Required
As Required
1006265 Shim (0.002")
1006266 Shim (0.003")
1006267 Shim (0.005")
=
•
Output Spindle
(see chart, above)
1019569 Bearing Cap
(LH Thread)
Tighten to 15
Inch Pounds torque.
S
) Indicates recommended spare part. Order
Termination
Code
--61
--62
--63
--64