Dotco 14CFS93-98 Manuel des pièces détachées - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel des pièces détachées pour {nom_de_la_catégorie} Dotco 14CFS93-98. Dotco 14CFS93-98 8 pages. 14cf series, shears & scissors
Imprimer la pagePL31-14CF-1
September 11, 2002
DISASSEMBLY
1. Loosen (3) cap screws. Remove shear head by twisting
and pulling forward.
2. Remove the (3) cap screws completely. Be careful not to
lose rear bushing when removing middle cap screw.
3. Remove center blade from shear housing by tapping
blade gently rearward. Be careful not to lose bushing
from hole in center blade. Both side knives will now drop
out of housing.
ASSEMBLY
1. Install spacer (part #1546) over planet cage, then
eccentric bearing assembly. Tighten bearing assembly.
Lubricate bearing with a good grade of bearing
grease.
Installing cutter blades:
2. Place the left side knife in position in the shear housing.
Insert center cap screw through housing and blade just
far enough to slip spacer bushing (part #14-1556) over
cap screw.
14CFS93-98 Scissors & 14CFS93-99 Shears
DOTCO
3. Place right side knife into position and push center cap
screw into thread just enough to hold blades in position.
DO NOT TIGHTEN.
4. Insert spacer bushing into hole in center blade and
lubricate with a good grade of bearing grease.
5. Install center blade into shear housing by tapping blade
gently forward, using a drift to line up hole in center blade
with forward holes in housing.
6. Insert and tighten forward cap screw, making sure spacer
bushing in center blade stays in position.
7. Apply a good grade of bearing grease to yoke of center
blade where it rides on the eccentric bearing assembly.
8. Insert rear cap screw but do not tighten.
Installing shear head assembly on tool:
9. Loosen all three cap screws about three or four turns.
10. Place shear head onto tool and tighten screws
snugly.NOTE: WHEN SHEAR HEAD IS PROPERLY
ASSEMBLED, CENTER BLADE WILL MOVE FREELY IN
HEAD.
Page 4