Electra VTM.7S402 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Electra VTM.7S402. Electra VTM.7S402 12 pages. Tl touch line audio & video terminals for tl door phone systems

Imprimer la page

1. Description of the Audio-Video Terminals

CALL DURATION The terminal rings only once. Touch the

The terminal rings twice. Touch the

The terminal rings three times. Touch the

The terminal rings continuously for 1 minute. Touch the

The last played version remains stored for call.

CALL RINGTONE VOLUME Successively touch the

volume of the ringtone. Each volume level, from 1 to 7, is signaled by an increase in the

intensity of the selected ringtone.

The last played version remains stored for the call.

The settings mode will automatically close after 7 sec. from the last action.

6.2

TIME and DATE setting for the

Touch the

key and enter the Menu.

Continue to touch the

Scroll using the

Adjust the parameters using the

for the correct setting. Select Exit to exit the Time & Date menu.

The manual programming of the address of the terminal (apartment number/ family)

All Touch Line terminals are programmed from the factory with address 1.

The terminals from apartments with numbers from 2 to 9999 will be programmed with

the number (address) of the respective apartment / family.

The address of the terminals with numbers from 2 to 20 can be manually programmed,

according to the following procedure:

0. The entire door phone system is installed and set under tension.

1. Go to the place where the SCU central unit of the installation is mounted. Long press

(2-3 sec.) the PROG button. The red LED turns on.

2. Return to the terminal and long touch the

- Programming address 1: touch the

- Programming address 2: touch the

- Programming address 3: touch the

Repeat the procedure for the next addresses, until 20.

NOTE: After pressing the

of the terminal for address n. The terminal will issue n beeps for address n programmed

in the terminal.

3. Return to the SCU central unit of the installation. Press the PROG button for a short time.

The red LED turns off. The installation returns to normal functioning mode.

For programming the Touch Line terminals installed in buildings with a high number

of apartments (higher than 15), purchase the special terminal address programming

device from the producer.

key until you reach the Time & Date.

keys and touch

Programming the audio-video terminals

key n times, wait a few seconds for the acoustic confirmation

key for the second time.

key for the third time.

extra

terminal

to select the Time or the Date.

keys and touch the

key. You will hear a long beep.

key once. A short beep is issued.

key twice. Two short beeps are issued.

key three times. Three short beeps are issued.

key again.

key for the fourth time.

key, until you reach the desired

key