Asus AAM6020BI-T4 Manuel de l'utilisateur - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Asus AAM6020BI-T4. Asus AAM6020BI-T4 38 pages. Cpe (customer premises equipment) adsl 4 port router

Imprimer la page

4.7

Tools

The CPE supports a host of tools which will allow you to customize and debug your CPE.

4.7.1

System Commands

To make the changes permanent you need to click on Tools (at the top of the page) and select System

Commands. The following commands are used to configure the CPE:

Save all: Press this button in order to permanently save the current configuration of the CPE. If

you do re-start the system without saving your configuration, the CPE will revert back to the

previously saved configuration.

Restart: Use this button to re-start the system. If you have not saved your configurations, the

CPE will revert back to the previously saved configuration upon re-starting. NOTE:

Connectivity to the unit will be lost. You can reconnect after the unit reboots.

Restore Defaults: Use this button to restore factory default configuration. NOTE: Connectivity

to the unit will be lost. You can reconnect after the unit reboots.

4.7.2

Remote Log

The remote log feature is used in conjunction with the PC tool (software provided with your CPE). For

PPPoE and PPPoA connections, you can select debug if you want to log the connection information. This

is helpful when trying to debug connection problems.

The remote log feature will forward all logged information to the remote PC. The type of information

forwarded to the remote PC depends upon the Log level. Each log message is assigned a severity level,

which indicates how seriously the triggering event affects router functions. When you configure logging,

you must specify a severity level for each facility; messages that belong to the facility and are rated at that

level or higher are logged to the destination

Table 1 defines the different severity levels.

To forward logging information, you need to click on Tools (at the top of the page) and select Remote Log.

4.7.3

User Management

You can change your CPE's username and password by going to the Home screen, under the tools menu,

click User Management. From here you can change the login name and password. You can also change

the idle timeout; you will need to log back onto the CPE once the timeout expires.

If you forget your password, you can press and hold the reset to factory defaults button for 10 seconds (or

more). The CPE will reset to its factory default configuration and all custom configurations will be lost.

Table 1 (Severity Level)

AAM6030BI User Manual