Doughpro Proluxe DP2000SC Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Doughpro Proluxe DP2000SC. Doughpro Proluxe DP2000SC 18 pages. 12" mold manual press

Imprimer la page

No. DPPC1. (See our catalog

and price list for information.)

Note: This spray will not affect

the taste of your crust in any

way.

6. Place your pre-portioned ball of

dough in the approximate center

of the lower platen. Add another

dash of spray to the top of the

dough ball.

7. Close the platen and pull the "U"

shaped handle down to

commence the pressing

operation.

8. Hold the handle down for as long

as you have determined to be the

appropriate amount of time for

your particular product and then

simply pull the handle back up

when you have completed.

9. Inspect your dough. If it is too

thick, rotate the thickness control

dial, located on the top of the

machine, to the line marked

"THIN". Reverse this procedure

if your product presses too thin.

Experiment with temperature,

dough weight, time, and pressure

until you arrive at the desired

result.

10. Remove the finished product by

rotating the upper platen out of

the way until you have sufficient

space to do so. Place the dough

on a screen or in a pan. Since the

shape of the dough may be

altered slightly in the transfer

process, some hand fitting may

be required. Add toppings, if

desired, and now you are ready

to bake.

ADDITIONAL NOTES:

Temperature

Note

Fahrenheit/Centigrade (Celsius)

Conversion

The temperature controller can

be programmed to display either

°F or °C. To change: Press the

MODE button until the

temperature is displayed, then

push and hold the SET button for

10 seconds.

Counter

The controller has a built in cycle

counter.

• Press MODE button until the

counter is displayed.

• Counter display range is 0000 to

9999.

• To reset the cycle counter,

display the counter reading, then

push and hold both UP ( ) and

DOWN ( ) arrow buttons for 3

seconds until the counter resets

to zero (0000) on the display.

Tightening the Pull-Down Handle

The pull-down pressing handle requires

adjustment periodically to prevent it

from free falling. Whenever the handle

seems too loose or is falling by itself, the

problem can be corrected easily and

quickly as follows:

1. Using a 3/16" hex shaped Allen

wrench, insert in key slot located

on the right beneath the upper

shroud.

2. Tighten until the press action of

the handle becomes firm but not

too tight.

-5-

DP2000-1725-7/04