Electric Eel E Manuel de sécurité et d'utilisation à l'intention des clients - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de sécurité et d'utilisation à l'intention des clients pour {nom_de_la_catégorie} Electric Eel E. Electric Eel E 6 pages. Drain cleaning machine
Également pour Electric Eel E : Manuel de l'opérateur (8 pages)
Imprimer la page
Step
1
Place the machine within 3 ft. of the drain or sewer clean out.
2
Attach a small spear-type cleaning tool to the end of the cable. This tool will enable you to bore a starter hole in the
obstruction, allowing backed-up water to drain.
3
Position foot actuator for easy operator accessibility.
4
Make sure FOR/REV switch is in the FORWARD position. Run the machine in forward at all times during cleaning
operation, use reverse only to dislodge tool lodged in pipe line.
5
With the machine in the off position, hand feed the cleaning tool and cable into the sewer line clean out as far as can be
easily done.
6
With gloved hands on cable, begin depressing the foot actuator to start the machine. ALWAYS keep two hands on the
cable in order to guide and control the rotating cable.
7
Apply downward pressure with gloved hands on cable; rotating cable will slowly work its way into the line.
8
Repeat steps 6 and 7 until the obstruction is met. This will become apparent as operator can no longer feed additional
cable into the line and/or cable slows or fails to rotate.
tool becomes stuck in the obstruction and cable fails to rotate. This will cause EXCESS CABLE TENSION and allow
the cable to kink, and/or break due to excess torque build-up. If tool becomes stuck, switch motor from Forward to
Reverse operation, and slowly back tool out of obstruction.
9
To work tool through obstruction, place toggle switch in FORWARD direction and begin running cable into line.
When the cable hits an obstruction and starts to load, the operator should pull on the cable in order to back tool away
from obstruction. This procedure should continue until tool has fully worked its way through the obstruction. NOTE:
For larger lines, it will be necessary to repeat steps 5 through 9 with a larger tool or blade after the obstruction has
been penetrated.
Customer Safety and
Operation Guide
Electric Eel Model R
100 Ft. Electric Snake 5/8" & 3/4"
Follow the steps below to operate the tool
Action
WARNING:
Email:
Website:
www.electriceel.com
DO NOT ALLOW machine to run when cleaning