Douglas Dynamics SnowEx HELIXX 1.5 yd3 Manuel d'instructions d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Douglas Dynamics SnowEx HELIXX 1.5 yd3. Douglas Dynamics SnowEx HELIXX 1.5 yd3 19 pages. Poly hopper spreaders

Imprimer la page
Vehicle Control Harness Installation
1. Plug the vehicle harness into the spreader harness.
2. Lay out a path for routing the vehicle control
harness from its attachment point on the vehicle
battery cable into the cab of the vehicle. Make sure
that the path avoids any hot, sharp, or moving parts
of the vehicle. Routing will vary from vehicle to
vehicle.
3. Choose a cab control mounting location that can
be reached by the harness. The location must
be within easy reach of the vehicle operator
without restricting access to vehicle controls or
instrumentation.
Do not mount the control in areas prohibited
by the vehicle manufacturer for reasons of
crashworthiness. See the vehicle's body builder's
book, owner's manual, or service manual for
details. The shaded portions in the illustration
below show the most commonly restricted areas.
CAUTION
Do not alter, modify, or install additional
components in shaded areas shown below.
Failure to comply may interfere with airbag
deployment or cause injury to operator in an
accident.
CAUTION
Before drilling any holes, check both sides
of the material for any wires, fuel lines, fuel
tanks, etc., that may be damaged by drilling.
4. Drill a 5/8" hole in the fire wall so that the vehicle
control harness can reach the desired cab control
location.
Lit. No. 74041, Rev. 00
WIRING AND HARNESS INSTRUCTIONS
5. Insert a rubber grommet into the hole.
6. Route the harness as laid out in Step 2.
7.
Secure the vehicle control harness to the vehicle.
8. Attach the red wire to a switched accessory circuit.
Cab Control Installation
1. Confirm that the chosen cab control mounting
position will not interfere with other equipment or
allow unintentional starting of the spreader.
2. Install the vehicle side of the mounting bracket
using three #10 x 3/8" Phillips head tapping
screws.
#10 x 3/8"
Tapping
Screws
Control Side
(Control not shown.)
3. Install the control side of the bracket to the control
using four #8 x 3/8" Phillips head machine screws.
12
Vehicle Side
#8 x 3/8"
Machine
Screws
June 15, 2019